Difference between revisions of "Constructing pi64"
From Jay's Cafe' Wiki
Jayctheriot (talk | contribs) m |
Jayctheriot (talk | contribs) m |
||
| Line 13: | Line 13: | ||
'''Begin installing base packages to compile vice-3.2.tar.gz'''<br /> | '''Begin installing base packages to compile vice-3.2.tar.gz'''<br /> | ||
<code> | <code> | ||
apt install bison flex xa65 libpcap* libsdl1.2*<br /> | sudo apt install bison flex xa65 libpcap* libsdl1.2*<br /> | ||
./configure --enable-sdlui --enable-ethernet --with-alsa --with-pulse --enable-realdevice<br /> | ./configure --enable-sdlui --enable-ethernet --with-alsa --with-pulse --enable-realdevice<br /> | ||
make<br /> | make -j (number of cores) <br /> | ||
sudo make install<br /> | sudo make install<br /> | ||
sudo apt install tcpser<br /> | sudo apt install tcpser<br /> | ||
Revision as of 02:42, 21 June 2018
Design objectives:
- a functional cycle-appropriate implementation of a C64/C128 with ethernet access on a Raspberry Pi Zero
- Minimal GUI using SDL1 as the base
Concerns
- the C64 or C128 will not perform near 100% of their original speed
- Use retropi as a base install
- Configure booting to self-login CLI
apt update
Begin installing base packages to compile vice-3.2.tar.gz
apt full-upgrade -y
sudo apt install bison flex xa65 libpcap* libsdl1.2*
./configure --enable-sdlui --enable-ethernet --with-alsa --with-pulse --enable-realdevice
make -j (number of cores)
sudo make install
sudo apt install tcpser
sudo reboot
Issues
Works fine, unless you add sound. Then the max execution speed goes from 300% to 30% in both x64 and x128.
I couldn't get tcpser to connect to x64 --- Fixed (I'm stupid) settings: ACAIA Emulation enabled Mode - Swiftlink 232 - enabled Configure device #1 as 127.0.0.1:25232 Port speed 38920 start a corresponding tcpser -v 25232 -l 4 (more/less)
