Difference between revisions of "Constructing pi64"
From Jay's Cafe' Wiki
Jayctheriot (talk | contribs) (Created page with "#Use retropi as a base install #Configure booting to self-login CLI #apt update #apt full-upgrade -y '''Begin installing base packages to compile vice-3.2.tar.gz'''") |
Jayctheriot (talk | contribs) m |
||
| (13 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
Design objectives: | |||
*a functional cycle-appropriate implementation of a C64/C128 with ethernet access on a Raspberry Pi Zero | |||
*Minimal GUI using SDL1 as the base | |||
Concerns | |||
*the C64 or C128 will not perform near 100% of their original speed | |||
#Use retropi as a base install | #Use retropi as a base install | ||
#Configure booting to self-login CLI | #Configure booting to self-login CLI | ||
<code>apt update<br /> | |||
apt full-upgrade -y<br /> | |||
'''Begin installing base packages to compile vice-3.2.tar.gz''' | </code> | ||
'''Begin installing base packages to compile vice-3.2.tar.gz'''<br /> | |||
<code> | |||
sudo apt install bison flex xa65 libpcap* libsdl1.2*<br /> | |||
./configure --enable-sdlui --enable-ethernet --with-alsa --with-pulse --enable-realdevice<br /> | |||
make -j (number of cores) <br /> | |||
sudo make install<br /> | |||
sudo apt install tcpser<br /> | |||
sudo reboot<br /></code> | |||
<p> | |||
'''Issues'''<br /> | |||
Works fine, unless you add sound. Then the max execution speed goes from 300% to 30% in both x64 and x128. | |||
<p> | |||
I couldn't get tcpser to connect to x64 --- Fixed (I'm stupid) | |||
settings: | |||
ACAIA Emulation enabled | |||
Mode - Swiftlink | |||
232 - enabled | |||
Configure device #1 as 127.0.0.1:25232 | |||
Port speed 38920 | |||
start a corresponding tcpser -v 25232 -l 4 (more/less) | |||
<p> | |||
Latest revision as of 09:03, 21 June 2018
Design objectives:
- a functional cycle-appropriate implementation of a C64/C128 with ethernet access on a Raspberry Pi Zero
- Minimal GUI using SDL1 as the base
Concerns
- the C64 or C128 will not perform near 100% of their original speed
- Use retropi as a base install
- Configure booting to self-login CLI
apt update
Begin installing base packages to compile vice-3.2.tar.gz
apt full-upgrade -y
sudo apt install bison flex xa65 libpcap* libsdl1.2*
./configure --enable-sdlui --enable-ethernet --with-alsa --with-pulse --enable-realdevice
make -j (number of cores)
sudo make install
sudo apt install tcpser
sudo reboot
Issues
Works fine, unless you add sound. Then the max execution speed goes from 300% to 30% in both x64 and x128.
I couldn't get tcpser to connect to x64 --- Fixed (I'm stupid) settings: ACAIA Emulation enabled Mode - Swiftlink 232 - enabled Configure device #1 as 127.0.0.1:25232 Port speed 38920 start a corresponding tcpser -v 25232 -l 4 (more/less)
